[josh_hays21]

Does anybody have bedrails installed. All I'm finding is for the rhino and would really like some for my viking

 

[Mass-n-trash]

I built my own because anytime you fill the bed up with something, the tie downs are almost impossible to get to. This works MUCH better.

 

[BadM0nkey]

Nice job Mass. Forever the innovator.

 

[Ben]

I like those. They look good and they look strong. I was thinking about building a set of died boards to aid in hauling firewood. Might build a set similar to yours. Well done sir.

 

[UTVHQ Bill]

Greetings everyone! We also carry Viking Bed Rails. Check them out here:UTV Headquarters - Viking Bed Rail - Accessory Mounts
We are also offering a 10% discount to forum members!

 

[Mass-n-trash]

Greetings everyone! We also carry Viking Bed Rails. Check them out here:UTV Headquarters - Viking Bed Rail - Accessory Mounts
We are also offering a 10% discount to forum members!

FYI: Those are not bed rails. That is the backing mount that goes under the lip of the bed for the OEM accessories.

 

[Robleticia]

Again with the forum discount.....DAMN IT!

 

[Jdawg]

Really like the spare tire carrier! Did you make it? If not where can I get one?
Thanks!

 

[Mass-n-trash]

Really like the spare tire carrier! Did you make it? If not where can I get one?
Thanks!

Thank you, I built that myself. Here's a video... [video=youtube;qcPMaCD6pDI]https://www.youtube.com/watch?v=qcPMaCD6pDI[/video]

 

[Jdawg]

Thank you, I built that myself. Here's a video... [video=youtube;qcPMaCD6pDI]https://www.youtube.com/watch?v=qcPMaCD6pDI[/video]

How much would you charge me to build me one for mine?

 

[Ben]

I agree with Jdawg. How much?

 

[RONN]

Put me on the list for one.

 

[Mass-n-trash]

How much would you charge me to build me one for mine?

Thanks for the interest Folks, but that was a one time shot with an old stick welder and scraps I had laying around. I wish I had access to a shop with a C&C and such...I would love to make a bunch of them!

 

[J.R.]

I made bed rail "guards" out of 1"x1" stainless steel angle from the local hdwe store. The stuff I bought had a rounded corner, not sharp & square like most regular angle iron. I cut it and drilled it and bolted it to the oem tapped holes in the bed rails; and, now I have made all sorts of brackets and things that bolt on top of the SS guards. IMO, these SS guards are awesome, they really protect the bed rails and make it hard and rigid. Once installed, one can make all sort of other "things" that bolt right on top of them. Let your imagination run wild!