[codyirelan545]

I'm going to build some heat shields to,go above the rear differential, looking for some input on material and thickness. What do you guys think? Aluminum? Steel? 1/16? 1/8?

Sent from my VS985 4G using Tapatalk

 

[mastertdb]

1/8 alum.


Sent from my iPhone using Tapatalk

 

[Robleticia]

Mine is 1/8" aluminum

 

[Nguyenbio]

Mine is 1/8" aluminum

View attachment 1721

Can you tell me approximately the dimensions on your heat shield and are those two separate pieces I see?

 

[tn blue Viking]

Has anyone had any trouble without adding heat shields?

 

[Mass-n-trash]

Has anyone had any trouble without adding heat shields?

Maybe not that anyone can prove...but the shield sure is CHEAP insurance!

 

[Robleticia]

^^^^this!!!


Sent from The Green Machine

 

[Robleticia]

Can you tell me approximately the dimensions on your heat shield and are those two separate pieces I see?

Sorry man, I just saw this. I'll measure tonight for ya. Soon as Street Outlaws is over!


Sent from The Green Machine

 

[Robleticia]

Piece on the left (driver side) is 3 1/3" x 13" and the piece on the right is 7" x 13". Both sides could be a little wider if you wanted?


Sent from The Green Machine

 

[Denny0816]

Rob I havnt even checked in to this yet is it possible to make it one piece or does if have to be two. Sorry for the dumb question just wondering without looking lol

 

[Nguyenbio]

Piece on the left (driver side) is 3 1/3" x 13" and the piece on the right is 7" x 13". Both sides could be a little wider if you wanted?


Sent from The Green Machine

Thank you sir!

 

[Robleticia]

No, there is a brace that runs the length of it and has like a 1/2" sticking up. You can see it in the photo.

 

[Denny0816]

Ok ya I already looked at mine but thanx Rob

 

[Denny0816]

finally got them mounted

 

[Ramrod]

Old street signs work good for this just put the lettering side down. My heat shields say no parking but nobody sees that part.