Yamaha Viking Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter · #1 ·
Got a winch on the back now should be covered from both ends
 

Attachments

·
Registered
Joined
·
58 Posts
Discussion Starter · #3 ·
Thanks schedule 40 steel pipe and 1/4 inch angle
 

·
Registered
Joined
·
58 Posts
Discussion Starter · #5 ·
I used the two bolt holes under the bed that the aftermarket bumpers use I also bolted the winch mount to the bed. You'll have to forgive my welds using a cheap welder
 

Attachments

·
Registered
Joined
·
67 Posts
Thanks for the pix and post it's helpful. I am getting ready to build one myself and wasn't sure on how to mount it I was actually thinking of making bars that would slide inside the frame and bolt it that way. I will investigate both options
 

·
Registered
Joined
·
67 Posts
Finally got around to building mine I used 2" square tubing a PC of 3x3" angle and 1 3/4" tube. And all the steel is heat treated LOL. Since I work for a heat treat plant i figured why not.


Sent from my XT1565 using Tapatalk
 
1 - 9 of 9 Posts
Top