Yamaha Viking Forum banner
1 - 1 of 1 Posts

· Registered
78 Posts
Discussion Starter · #1 ·
While I was checking over my V-6 tonight, I noticed the intake side clamp must have come loose. I noticed by seeing the intake tub a little ways out.(see photo) this was as far as it could move outwards. it didn't let in water or dirt. biggest concern would be water. I removed the middle rear floor pan and the middle seat. 4 bolts for the seat and 6 for the floor plus 2 screw clips. While I was there I greased the slip spine on the front drive shaft. Just slide the rubber cover forward and add a little grease and replace the rubber boot.


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.