Yamaha Viking Forum banner
1 - 20 of 26 Posts

·
Premium Member
Joined
·
571 Posts
Awesome
 

·
Registered
Joined
·
52 Posts
Discussion Starter · #6 ·
Looks great lifted up!

Where did you get that rack that holds the tire and goes over the bed?
I fabbed it from 1 1/2 95wall cage pipe. And thanks
 

·
Registered
Joined
·
52 Posts
Discussion Starter · #7 ·

·
Registered
Joined
·
52 Posts
Discussion Starter · #12 · (Edited)
Looks awesome but i gotta ask how did you secure the pipe to the bed? And it looks like the bed is still dumpable?
yes it still dumps I tied it into the stock mount holes on the bottom of the bed and thanks and I welded the cage to a piece angle iron 3/16 thick x 2 inch and drilled 3 , 1 1/4 inch holes in side for tie downs and bolted the whole thing with the 4 exposed bed rail holes
 

·
Registered
Joined
·
185 Posts
That looks awesome, I love seeing the custom fab. stuff on these forums, I am green with envy that I don't have that ability
 

·
Registered
Joined
·
21 Posts
Well done yamacat, that looks BA!
 

·
Registered
Joined
·
52 Posts
Discussion Starter · #16 ·
yamacat,
how much does your cv's bind with the 3'' lift?,would itbe too much to ask pics of the axles?
thanks
They don't bind at all I had more lift and that made them bind at full extension... needed more lift in rear to compensate for sag but couldn't so went back to just 3in then preloaded spring with 1/2in spacer. so when shock is at full extension and it wont allow it to extend to binding. and in front the only thing I had to do is toe out a tad. hope this helps ill start a new thread on axle angle and lifts... thanks for looking
 

·
Registered
Joined
·
52 Posts
Discussion Starter · #17 ·
Thanks everybody for the compliments!!! Makes a guy feel like he's doing it right haha
 

·
Registered
Joined
·
185 Posts
Yamacat where are you from

Sent from my SAMSUNG-SM-N900A using Tapatalk
 

·
Registered
Joined
·
52 Posts
Discussion Starter · #20 ·
1 - 20 of 26 Posts
Top