Yamaha Viking Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Hi

Just installed my superatv rear windshield so I haven't much time to do a good review but this it what I noticed so far
fits good pretty easy to install.bit tight against the box on the bottom.
Box dumps but it rubs the bottom couple of inches of the window when closing.
Seems a bit quieter in the cab but could just be in my mind only drove it 1000yrds after install.
A little buzzing vibration when driving likely where it contacts the dump box..if there were a couple clamps down low to secure it might fix the buzz.
 

Attachments

·
Registered
Joined
·
21 Posts
Discussion Starter · #4 ·
Time will tell I guess. I was thinking about drilling a couple holes in it near the middle at the bottom and putting a couple cable ties around the bars to pull it away the bed.
I stopped the "buzzing"i had a little piece of the rubber seal left over so I put it on the top where it made contact with the roof. I'll get a longer piece and run it the entire length of the top of the windsheild.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top