Yamaha Viking Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hey guys I need help I'm running 29.5 outlaw 2's with 2" lift everything is great except for extreme left or right turns then I get a little rub on the inside of my fender well... I've searched high and low for wheel spacers.. I even bought a set but couldnt use them.. first off my 12mm wheel stud don't protrude through the hub enough 2nd they had 10mm studs coming out of the spacer and I'd really like to keep my lugs I have now... they were 2" spacers...the only spacer I can find for a 12mm lug is 4/110 for Honda big red utv . But nobody can tell me if these spacers have 12 or 10 mm lugs coming out of the spacer... any help will be greatly appreciated
 

·
Registered
Joined
·
7 Posts
Discussion Starter #3
Thanks but I already have aftermarket wheels and tires and I don't really want to have to purchase another set just for wider stance... not sure of the off set on my wheels I'll have to check
 

·
Premium Member
Joined
·
571 Posts
What wheels do you have, mine have 5+2, and they stick out very little, if at all over stock.
 

·
Registered
Joined
·
7 Posts
Discussion Starter #5
Msa Kore 20 14" with 29.5x9.5 outlaw 2's. I'm not 100% of the off set mine don't really stick out and when I lifted 2 inches it pulled them in a little. I really like the looks of a wide stance I just wish I could find the proper wheel spacer. I found a few but when I researched deeper I found that they were made for 10mm studs
 
1 - 5 of 5 Posts
Top